How To Install a Split System Air Conditioner

Image result for ac installation

A split system air conditioner is an excellent option for keeping your home comfortable and cool in the summer months. This sort of A/C is ductless, so all you need to do is install the cooling unit inside along with the compressor and condenser unit outside, then run piping along with an electricity cable between the two units. If you do not want to hire a professional to set up a split system air conditioner and you’ve got some experience with plumbing and electrical work, you can install the device by yourself. Every air conditioning unit is unique to its manufacturer, but the general installation process is the same.

Select an unobstructed place in your interior wall to mount the unit. You’ll want to cut a hole through the wall to feed the pipes in the indoor unit to the outdoor unit, so be certain the place you choose will allow you to achieve that. Choose a spot away from direct sunlight and heat sources for the best outcomes. Mount the unit 7 ft (2.1 m) off the floor and ensure there’s at least 6–12 inches (15–30 cm) of open area on each side of the unit to allow for proper airflow.

Choose a location with studs to ensure the wall is strong enough to hold the weight of this unit.

Install the device at least 3.3 ft (1.0 m) from antennas and power or connecting lines that are used for radio, television, home security systems, intercoms, or telephones. The electrical noise from such sources can cause operational problems to your air conditioner.

Prevent locations where gas may leak or where oil mist or sulfur is present.

Tip: Choose a central place for the indoor unit in which the cool air can easily flow throughout your house, like in the living area.

Secure the mounting plate to the interior wall. Hold the mounting plate against the wall where you would like to put it in the unit. Use a level to make sure it is both horizontally and vertically level. Use a pencil to mark the areas of the screw holes, then remove the plate, then drill a hole into the wall where each screw will proceed.

Position the plate so it matches up with all the holes, insert plastic anchors into the holes, and fasten the plate into the wall with tapping screws.
Make a mark in the middle of this hole in the mounting plate. Use a keyhole saw or a drill using a hole-cutting attachment to make a circular 3 in (7.6 cm) opening the wall that slopes slightly downward toward the ground to ensure adequate drainage. You can also check out ac repair westlake oh

Make sure that there are no pipes or wires behind the wall prior to drilling or cutting the gap.

Be sure the cable wires are connected to the screw terminals and that the wiring fits the structure that came with the unit.

Run the pipes and cables through the hole in the wall, then connect them to the device. Safe the included aluminum pipes, power cable, and drain pipe together with electrical tape. Set the drainpipe on the bottom to ensure a free flow of water. Run the cable and pipes through the hole in the walls, then secure them into the specified areas on the indoor unit as instructed by the instruction manual.

Every line comes pre-insulated, which means you don’t need to worry about adding extra insulation.

Do your best to minimize how much the pipes and cable bend to ensure that the unit works well.

Be sure the drainage pipe allows water to drain at a proper location. See the documentation included with your kit to learn more.